Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
INSTALLATION
NOTE:
The mounting system may be attached to:
•
a bare 8" concrete or 8"x8"x16" concrete block wall; or
•
a 2" x 4" wood studs (16" on center minimum) wall with
a minimum drywall thickness of 1/2" (12.7mm); or
•
a 2" x 4"-25ga minimum steel studs (16" on center
minimum to 24" on center maximum) wall with a
minimum drywall thickness of 1/2" (12.7mm).
Determining Location
NOTE:
Use the installation template (included) to assist in
placing and installing the AN3 mounting system.
1.
Place template against wall, with "TOP EDGE OF
SCREEN" line placed at desired location.
Figure 1
IMPORTANT ! : Be sure there is a MINIMUM of 1"
between the top of mount and the ceiling. See
Installation Template.
IMPORTANT ! : The lower mounting holes of the
projector mount are either 16" or 17" above the screen
wall bracket mounting position, dependent on type of
projector. See Installation Template and DIMENSIONS
drawing for specific information.
2.
Determine projector type that will be used:
Lamp-Style
•
BrightLink Pro 1450Ui
•
BrightLink Pro 1460Ui
•
BrightLink 696Ui
•
BrightLink 697Ui
Laser-Style
•
BrightLink Pro 1470Ui
•
BrightLink 710Ui
3.
Determine location of studs behind drywall, line-up
Installation Template with studs, and fasten Template to
wall at determined location.
Template
Installing Projector Mount Wall Bracket
WARNING:
ELECTRICAL SHOCK HAZARD! CUTTING
OR DRILLING INTO ELECTRICAL CORDS OR CABLES
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is free
of electrical wires and cables before cutting, drilling, or
installing fasteners.
WARNING:
EXPLOSION AND FIRE HAZARD! CUTTING
OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH
OR SERIOUS PERSONAL INJURY! ALWAYS make certain
area behind mounting surface is free of gas, water, waste, or
any other plumbing before cutting, drilling, or installing
fasteners.
[OPTIONAL] Projector Mount Wall Bracket Uprights
Adjustment
IMPORTANT ! : The projector mount wall bracket (U)
uprights are factory positioned for 24" stud spacing. The
uprights may be adjusted to accommodate 16" on-center
stud walls.
1.
Loosen two flat head cap screws on projector mount wall
bracket (U). (See Figure 2)
2.
Slide wall bracket uprights to corresponding width of studs.
(See Figure 2)
3.
Tighten two flat head cap screws on wall bracket (U). (See
Figure 2)
1
2
V12H949001 / AN3WA100
3
2
Figure 2
7
Publicité
Table des Matières
