Epson V12H949001 Instructions D'installation page 19

Installation Instructions
9. Attach the two magnetic markers (included with the
BrightLink projector) to the positions shown on the projected
image. (See Figure 39)
Blue marker
position
Figure 39
10. Match the positions so that the crosses (1) overlap with the
points (2) on the marker positions noted on the projected
image. (See Figure 40)
11. Move the marker over the projected cross until the lines of
the cross align with the lines on the marker. (See Figure 40)
Figure 40
12. When circles with the same color (blue or green) as the
NOTE:
Green marker
position
NOTE:
13. When the circles are inside the target, the circles become
V12H949001 / AN3WA100
marker positions are displayed on the left and right of the
screen, turn the adjustment dials on the touch sensor to
move the blue and green circles inside the target of the
same color (blue and green) on either side of the screen.
(See Figure 41).
Turning an adjustment dial clockwise moves the circle
diagonally up towards the center of the projected
image. (See Figure 41)
Target
Blue
circle
Figure 41
Turning an adjustment dial counterclockwise moves
the circle diagonally down away from the center of the
projected image. (See Figure 42)
Figure 42
solid.
Green
circle
19