Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
3.
Loosen screw at bottom of the touch sensor front.
NOTE:
The loosened screw stays in the touch sensor cover.
NOTE:
The touch sensor is included with the Epson projector,
not this All-in-One Mount System.
4
Figure 28
4.
Remove and keep touch sensor cover. (See Figure 28)
5.
Attach touch sensor to sensor mount assembly (S) by
placing two mounting holes in touch sensor over pins on
face of sensor mount assembly. (See Figure 29)
6.
Using one M4 x 25mm Phillips cap head screw (G2), fasten
touch sensor into place. (See Figure 29)
NOTE:
Insert the Phillips screw (G2) into hole at center
towards bottom front of touch sensor. The magnets on
the touch sensor will hold the touch sensor in place on
the bracket while tightening the screw (G2).
7.
Attach touch sensor cable to the touch sensor.
[Projector not shown]
(Touch sensor)
Figure 29
Touch
sensor
5
Pins
(S)
6
(G2) x 1
CALIBRATION
IMPORTANT ! : The interactive pens that shipped with
the projector MUST be calibrated before calibrating the
rest of the system.
Calibrating Pens Automatically
1.
Using the remote control, select User button. (See Figure 30)
Figure 30
2.
Follow directions on the screen to complete pen calibration.
NOTE:
Once the pens are calibrated, you will calibrate the
touch function of the interactive projector.
Calibrating the Touch Function
1.
Select Easy Interactive Function from the Extended
menu. (See Figure 31)
Figure 31
2.
Select Touch Unit Setup. (See Figure 32)
Figure 32
V12H949001 / AN3WA100
17
Publicité
Table des Matières
