Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V12H949001 / AN3WA100
3.
Select Power and set to On. (See Figure 33)
Figure 33
NOTE:
The Touch Unit power turns on and the indicator light
turns blue. (See Figure 34)
Figure 34
4.
Select Angle Adjustment. (See Figure 35)
Figure 35
18
Indicator light
5.
Select Installing the Touch Unit without the bracket.
(See Figure 36)
NOTE:
The bracket included with the projector (and shown in
Figure 36) will NOT be used.
Figure 36
6.
The Angle Adjustment screen is displayed. (See Figure 37)
Figure 37
7.
Turn the adjustments dials on the touch sensor
counterclockwise just until you hear a click. Do not over-
turn. (See Figure 38)
IMPORTANT ! :
When adjusting the dials on the touch
sensor, be sure to stop turning when you hear the "click".
8.
Then, press the
Figure 38
Installation Instructions
button on the remote control.
Publicité
Table des Matières
