Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V12H949001 / AN3WA100
Adding Screen Brackets to Screen
IMPORTANT ! : Be sure to install all 5 screen brackets
(EE) to ensure rigidity of the installation.
NOTE:
After image alignment use 3 screen brackets (EE)
along bottom of screen, and locate brackets as close to
outer corners as possible. Remaining two brackets are
used along top of screen. (See Figure 24)
Screen bracket
locations (EE)
Figure 24
NOTE:
The screen brackets (EE) used along the top of the
screen MUST be installed in the upright position. (See
Figure 25)
NOTE:
Screen brackets along bottom of screen may be
installed in the upright position or upside down.
Screen bracket
in upside down
position
Figure 25
NOTE:
It may be easier to swing the bottom of the screen away
from the wall to install the three lower screen brackets.
1.
Install screen brackets (EE) to wall using:
•
Wood/steel studs/drywall: one #8 x 1-1/2" screw
(CC) into back of each screen bracket. (See Figure 26)
•
Concrete wall: one #8 x 1-1/2" screw (CC) into back of
each screen bracket, and into installed 1/4" alligator
anchor (BB).
2.
Fasten brackets to channel in screen frame using one
#8 x 1/2" self-drilling screw (AA) per screen bracket (EE).
(See Figure 26)
16
1
Installing Sensor Bracket and Touch Sensor
IMPORTANT ! :
the top frame by a removable strip of red adhesive tape. The
touch sensor mount assembly should be centered at this mark.
NOTE:
1.
NOTE:
2.
Screen bracket
in upright position
1
2
2
(EE)
(CC x 5)
Figure 26
Center of screen is marked at the center of
The touch sensor is included with the Epson projector,
not with this All-in-One whiteboard mount.
Center sensor mount assembly (S) over screen and mark
mounting holes (one on left and one on right). (See Figure 27)
Power cable, video cable and Control Pad cables [2
USB and 1 remote cable (3.5mm stereo mini jack)] can
be routed behind the sensor mount before fastening to
wall. The power and video cables may be routed
behind the sensor mount depending on power and
video locations.
Install sensor mount assembly (S) using:
•
Wood/steel studs/drywall: one #8 x 1-1/2" screw (F2)
into each side of sensor bracket. (See Figure 27)
•
Concrete wall: one #8 x 1-1/2" screw (F2) into each
side of sensor bracket, and into installed 1/4" alligator
anchors (F3).
(F2) x 2
Figure 27
Installation Instructions
(AA x 5)
channel
(S)
Screen
(front view)
Publicité
Table des Matières
