Installation Instructions
Adding Covers
1.
Reattach the touch sensor cover, using the retained
fastener still remaining in the cover. (See Figure 55)
1
Figure 55
2.
Lower the upper cover (L) onto the projector mount.(See
Figure 56)
Figure 56
2
(L)
3.
Raise the lower cover (M) to the projector mount and fasten
through upper cover (L), lower cover (M) and into wall
mount with two 8-32 x 1/2" Phillips pan head screws (H1).
(See Figure 57)
Figure 57
4.
Place wall bracket top covers (J) over top of each mounting
bracket arm. (See Figure 58)
(J) x 2
4
(K) x 2
6
(Mount accessory arm not shown for clarity)
Figure 58
V12H949001 / AN3WA100
(H1) x 2
3
(M)
3
23