Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Projector Mount Adjustments
2
Micro Adjust
knob for #2
4a
5a
Macro Adjust
knob for #1
The projector mount assembly (V) ships pre-set. However,
adjustment information is included so that minor adjustments
may be made, if required.
IMPORTANT! The Macro Adjust knobs are used ONLY for large adjustments. You should only have to use the smaller Micro
Adjust knobs (also labeled above) to make minor adjustments. If a large adjustment is required, turn Macro Adjust knob
counterclockwise
to allow adjustment, and then turn clockwise to lock in place. Macro Adjust knobs MUST be locked in place
before it
is possible to make minor adjustments with the Micro Adjust knobs.
1
1. Adjust knob
1
as required.
*
After any necessary adjustments to knobs 1, 2 and 3, tighten the three locking screws (see above).
4
1.
Loosen two hex head bolts
under projector mount assembly
2.
Slide projector mount assembly left
or right as necessary.
3.
Tighten two hex head bolts
under projector mount assembly
6a
6a
6
5
Macro Adjust
knob for #2
3
*
1.
Adjust knob
4a
1.
Loosen two hex fasteners
on strap on bottom of boom arm.
2.
Slide boom arm in or out as
necessary.
4a
3.
Tighten two hex fasteners
on strap on bottom of boom arm.
4a
Micro Adjust
knob for #3
Macro Adjust
knob for #3
1
Micro Adjust
knob for #1
2
*
2
as required.
5
5a
5a
Figure 23
V12H949001 / AN3WA100
4
3
1.
Adjust knob
3
as required.
6
1.
Loosen two hex head bolts
6
2.
Rotate
clockwise to raise arm,
and counterclockwise to lower arm.
3.
Tighten two hex head bolts.
Locking
screws
*
6a
6a
15
Publicité
Table des Matières
