Epson V12H949001 Instructions D'installation page 22

V12H949001 / AN3WA100
8. Install control pad (included with projector) by slipping the
control pad plates (N) that were installed on back of control
pad into the slots on the control pad bracket (X) and allow
control pad to hang from the control pad plates. (See
Figure 51)
(N)
Control
pad
Figure 51
9. Connect cables (run along screen frame) from projector
mount to connectors in control pad. (See Figure 52)
10. Run cables from the connectors through the left side of the
control pad bracket and then behind the screen edge. (See
Figure 52)
10
Lay cables
here and
then behind
edge of
screen
Figure 52
22
8
(X)
[View from back of screen]
9
Attach Remote Holder Bracket
1. Install the remote holder bracket (W) to the top of the
control pad bracket and attach using one 8-32 x 3/8" Phillips
head screw (G1). (See Figure 53)
(G1) x 1
1
Figure 53
Attach Marker Tray
1. Attach marker tray (Q) at any point along bottom of screen
using two #8 x 1/2" self-drilling screws (F1). (See Figure 54)
(Q)
1 (F1) x 2
Figure 54
Installation Instructions
1
(W)
Screen