Medela Swing Mode D'emploi page 29

Milk in Motor
Note
This equipment has been tested and found to comply with the limits for a Class
•
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
Turn off the pump and unplug from power source.
1. Open the battery cover, remove the expanded-plastic liner. Wash
the expanded-plastic liner with clear, lukewarm water and squeeze out
well. Allow to dry thoroughly.
2. Pour about 2 oz of warm soapy water into a container.
3. Connect the tubing and the power cable onto the pump.
4. Hold the device with the control button upwards over a basin and
switch on. Press
pressing twice.
5. Hold the end of the tubing that is not connected to the pump in
the container with the soapy water.
6. The water is pumped through the tubing into the device.
Allow it to pump until all the water has been flushed through.
7. Repeat procedure with 1 oz of clear, warm water.
8. Then leave the device switched on for 3 minutes, until the pump
is completely dry.
9. As soon as the expanded-plastic liner is dry, put it in place again
and close the battery cover.
10.If necessary, clean the pump set according to cleaning instructions
"Prior to first use and once daily".
and ensure that the lowest vacuum level is set by
29