Permissible Accessories; Storage And Handling Of The Recommended Accessory Tools; Working Procedures - Parkside PWS 230 D4 Traduction Des Instructions D'origine

Permissible accessories

Cutting disc
Roughing disc
Storage and handling of the recom-
mended accessory tools
■ Grinding tools are to be treated with care and
transported carefully.
■ Grinding tools should be stored in such a way
that they are not exposed to mechanical
damage or environmental influences (e.g.
moisture).

Working procedures

NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding
Never use cutting discs
for rough grinding!
■ Move the angle grinder with moderate pres-
sure back and forth over the workpiece.
■ For soft material, move the rough grinding
disc at a shallow angle over the workpiece;
for hard material at a slightly steeper angle.
■ 8 │ GB │ IE
230 3 M14
230 6 M14
Two-hole assembly
6500 80
Two-hole assembly
6500 80
Abrasive cutting
Never use roughing discs
for cutting!
■ Use only tested fibre-reinforced cutting or
grinding discs that are approved for a circum-
ferential speed of not less than 80 m/s.
CAUTION!
► The grinder continues running after being
turned off. Do not try to brake it by applying
lateral counterpressure.
■ Secure the workpiece! Use clamps/a vice to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■
Always switch off the appliance before
putting it away and wait for the appliance to
come to a complete standstill.
■
Release the ON/OFF switch immediately in
the event of a power failure or when the plug
is pulled out. Move it into the OFF position. This
prevents an uncontrolled restart.
■ Use the appliance only for dry cutting or
sanding.
■ The additional handle
the appliance for all work.
■
Materials containing asbestos may not be
processed. Asbestos is a known carcinogen.
Yes
spanner
Yes
spanner
must be mounted on
PWS 230 D4