Parkside PWS 230 D4 Traduction Des Instructions D'origine page 13

Tip! This symbol indicates
proper behaviour.
DANGER! ALWAYS GUIDE THE
APPLIANCE THROUGH THE WORK-
PIECE IN REVERSE ROTATION.
► In the opposite direction there is a risk of
a kickback. The appliance can be pushed
out of the cut.
■ Always switch the appliance on before
applying it to the workpiece. After completing
the task, lift the appliance from the workpiece
and then switch it off.
■
Always hold the appliance firmly with two
hands while working. Ensure that your stance
is secure and stable.
■ For an optimum grinding effect, move the appli-
ance evenly at an angle of 15° to 30°
(between grinding disc and workpiece) back-
wards and forwards.
■ When working on angled surfaces, do not
exert great force on the workpiece. If the rota-
tional speed drops significantly, you must
reduce the pressure exerted to allow safe and
effective working. If the appliance suddenly
brakes completely or jams, it must be switched
off immediately.
■ Cutting: Work at a moderate feed rate and
do not tilt the cutting disc.
■ Roughing and cutting discs become very
hot – let them cool down completely before
touching them.
■ Never use the appliance for purposes other
than the ones for which it was designed.
■
Always make sure that the appliance is
turned off before plugging it into the wall
socket.
■ In case of danger, remove the plug from the
socket immediately. Ensure that the appliance
and the power socket are easily and quickly
accessible in the event of an emergency.
PWS 230 D4
■ Always remove the plug from the power
socket during work breaks, when adjusting
the appliance and when it is no longer in use.
The appliance must be kept clean, dry and free
of oil and grease at all times.
■ Remain alert at all times! Always pay atten-
tion to what you are doing and act with
common sense. Do not use the appliance if you
are distracted or feeling unwell.
WARNING!
Always wear safety goggles.
WARNING!
Always wear a dust mask!
GB │ IE │ 9 ■