Permissible Accessories; Storage And Handling Of The Recommended Accessory Tools; Working Procedures - Parkside PWSA 20-Li B3 Traduction Des Instructions D'origine

Permissible accessories

Max.
diameter
Ø (mm)
Cutting disc 125
Roughing disc 125

Storage and handling of the recommended accessory tools

■ Grinding tools are to be treated with care and transported carefully.
■ Grinding tools should be stored in such a way that they are not exposed to mechanical damage or
environmental influences (e.g. moisture).

Working procedures

NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding:
Never use cutting discs for rough
grinding!
■ Move the angle grinder with moderate pres-
sure back and forth over the workpiece.
■ For soft material, move the rough grinding
disc at a shallow angle over the workpiece;
for hard material at a slightly steeper angle.
Abrasive cutting:
Never use roughing discs for
cutting!
■ Use only tested fibre-reinforced cutting or
grinding discs that are approved for a circum-
ferential speed of not less than 80 m/s.
CAUTION!
The grinder continues running after being turned
off. Do not try to brake it by applying lateral
counterpressure.
PWSA 20-Li B3
Max.
Thread
thickness
size (mm)
(mm)
3 M14
6 M14
Max Max. cir-
speed cumferential
(rpm) speed (m/s)
12250 80
12250 80
■ Secure the workpiece. Use clamps/a vice to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■ Always switch off the appliance before put-
ting it down and wait for the appliance to
come to a complete standstill.
■ Use the appliance only for dry cutting or
sanding.
■ The additional handle
the appliance for all work.
■ Materials containing asbestos may not be
processed. Asbestos is a known carcinogen.
Tip! This symbol indicates proper be-
haviour.
DANGER! ALWAYS GUIDE THE APPLI-
ANCE THROUGH THE WORKPIECE IN
REVERSE ROTATION.
► In the opposite direction there is a risk of
kickback. The appliance can be pushed out
of the cut.
■ Always switch the appliance on before apply-
ing it to the workpiece. After completing the
task, lift the appliance from the workpiece and
then switch it off.
■ Always hold the appliance firmly with two
hands while working. Ensure that your stance
is secure and stable.
Blade
Tool
guard
Two-hole mounting
spanner
Two-hole mounting
spanner
must be mounted on
GB │ IE │ NI │
Yes
Yes
9 ■