Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
B
EFORE YOU
L
OCKING AND UNLOCKING THE GUN
WARNING
Always lock the trigger off when attaching the spray tip or
when the spray gun is not in use.
L
OCKING THE GUN
The gun is secured when
the trigger lock is at a 90°
angle (perpendicular) to the
trigger in either direction.
U
NLOCKING THE GUN
To unlock the gun, turn the
trigger lock to be in line with
the trigger.
The spray tip SHOULD NOT be attached until after the
sprayer and spray hose has been purged and primed.
P
LUGGING IN THE SPRAYER
1. Check that the ON/OFF switch is in the OFF
postion.
2. The connection must be made by correctly
grounded plug socket.
P
RESSURE RELIEF
WARNING
Be sure to follow the pressure relief procedure when
shutting the unit off FOR ANY PURPOSE. This procedure is
used to relieve pressure from the spray hose.
1. Lock the spray gun off and
flip the ON/OFF switch to
the OFF position.
2. Turn the PRIME/SPRAY
knob to PRIME.
© 2007 J. Wagner GmbH - All rights reserved.
© 2007 J. Wagner GmbH - All rights reserved.
B
EGIN
P
ROCEDURE
3. Unlock the spray gun and
then trigger it onto a scrap
piece of wood or cardboard.
4. Lock the spray gun.
--
T
HIS PAGE CONTAINS INFORMATION THAT WILL BE
REPEATED THROUGHOUT THE MANUAL
E
MPTYING THE
Follow these instructions if the hopper is filled with material
and 1) your sprayer malfunctions or 2) you finish your
spraying project without using all the material in the hopper.
1. Perform all the steps of the Pressure Relief Procedure (page 5).
2. Remove the lid from the hopper.
3. Grab top handle of the sprayer with one hand, grab rear
handle with the other.
4. Lift and tilt the sprayer so that material will pour from one of
the front corners of the hopper and into its original container.
Top
handle
Front
corners
WARNING
The unit, when filled with
spraying material, can be
heavy. Make sure to lift with
your legs and not your back
in order to reduce the risk
of injury.
P
S
AINT
TRAINING
It is recommended that in order to avoid premature tip and filter
clogging you should strain your paint before spraying. Follow
manufacturer's recommendations.
C
C
HOOSING THE
Use the proper gun filter based on the tip size being used.
Tip Size
Paint
409
For thin materials like
40° spray angle/ - Acrylic paints
0,23 mm hole
- Primers
- Stains...
515
For thick materials like
50° spray angle/ - Internal emulsions
0,38 mm hole
- Latex paints
- Hollow-space sealants...
19
19
.
H
OPPER
Rear
handle
CAUTION
Make sure your floors and
furnishings are protected
with drop cloths to avoid
property damage.
S
G
ORRECT
PRAY
UN
Filter
Red filter
White filter
English
F
ILTER
Publicité
Table des Matières
