Before You Begin; Emptying The Hopper - WAGNER PAINT CREW Mode D'emploi

BEFORE YOU BEGIN

GB
Locking and unlocking the gun
WARNING
Always lock the trigger off when attaching the spray tip
or when the spray gun is not in use.
Locking the gun
The gun is secured when the
trigger lock is at a 90° angle
(perpendicular) to the trigger
in either direction.
Unlocking the gun
To unlock the gun, turn the
trigger lock to be in line with
the trigger.
The spray tip SHOULD NOT be attached until after the
sprayer and spray hose has been purged and primed.
Plugging in the sprayer
1) Check that the ON/OFF switch is in the OFF
postion.
2) The connection must be made by
correctly grounded plug socket.
Pressure relief procedure
WARNING
Be sure to follow the pressure relief procedure when
shutting the unit off FOR ANY PURPOSE. This procedure
is used to relieve pressure from the spray hose.
1) Lock the spray gun off and
flip the ON/OFF switch to the
OFF position.
2) Turn the PRIME/SPRAY knob
to PRIME.
3) Unlock the spray gun and
then trigger it onto a scrap
piece of wood or cardboard.
4) Lock the spray gun.
24

Emptying the hopper

Follow these instructions if the hopper is filled with
material and 1) your sprayer malfunctions or 2) you finish
your spraying project without using all the material in
the hopper.
1) Perform all the steps of the Pressure Relief Procedure
(page 24).
2) Remove the lid from the hopper.
3) Grab top handle of the sprayer with one hand, grab rear
handle with the other.
4) Lift and tilt the sprayer so that material will pour from one
of the front corners of the hopper and into its original
container.
Top
handle
Front
corners
WARNING
The unit, when filled with
spraying material, can be
heavy. Make sure to lift with
your legs and not your back
in order to reduce the risk of
injury.
Paint straining
It is recommended that in order to avoid premature tip
and filter clogging you should strain your paint before
spraying. Follow manufacturer's recommendations.
Choosing the correct spray gun filter
Use the proper gun filter based on the tip size being used.
Tip Size Paint
XS
For thin materials like acrylic
40° spray angle/ paints, primers, stains...
0,23 mm holeg
M
For thick materials like
50° spray angle// internal emulsions, latex
0,38 mm hole paints, hollow-space
sealants..., ...
Paint Crew
Rear
handle
CAUTION
Make sure your floors
and furnishings are
protected with drop
cloths to avoid property
damage.
Filter
Red
yellow