WAGNER PAINT CREW Mode D'emploi page 16

S
AFETY
INFORMATION BEFORE OPERATING THE EQUIPMENT
U
SABEL MATERIALS
Only for water based materials.
- Internal emulsions
- Paints
- Acrylic paints
- Glazes
- wood preservatives
- Mordants
- Primers
- Wash primer
- Plant protective agents
- Under sealants
- Hollow-space sealants
- Disinfection agents
- Oils
U
NSUITABLE MATERIALS
- Solvent based paints and lacuers
- Paints and lacquers containing heavily abrasive
components like outdoor emulsion / dispersion wall
paints
- Silicate paints
W
Airless-equipment creates an extreme high spray
pressure.
1. Never bring fingers, hands or other body parts in contact with
the spray jet!
Never point the spray gun at oneself, other persons or
animals.
Never operate the spray gun without protection.
Attention!
Injury hazard through injection underneath the
skin!
With skin injuries caused by coating material or solvents
immediately consult a physician. Inform the physician
regarding the used coating material or the solvent that caused
the injury.
2. In accordance with the manual, following rules should be
observed prior to each start-up:
1. Faulty equipment is not to be operated.
2. Secure Wagner-spray gun with safety catch at trigger
handle.
3. Verify earth.
4. check all connections for tightness.
Instructions for regular cleaning and maintenance of the
equipment should be followed strictly.
English
I
NFORMATION
!
ARNING
•
R
EAD ALL
3. Prior to all maintenance on the equipment and after every
interruption following guidelines should be observed:
1. Relieve pressure in spray gun and hose.
2. Secure Wagner-spray gun with safety catch at trigger
handle.
3. Switch off motor.
Pay attention to safety!
S
AFETY INSTRUCTIONS FOR
AIRLESS SPRAYING
1. Read the manual carefully and follow the given instructions
to avoid danger.
2. Only use spray materials with a flash point of 21°C (32°C in
UK) or higher, without additional heating.
3. In workplaces falling under the explosion protection
regulations, the equipment is not to be used.
4. When spraying, there should not be any ignition sources in
the area; e.g. open fire, smoking of cigarettes, cigars or
tobacco-pipes, sparks, incandescent wire, hot surfaces etc.
5. Attention! Hazard of injury through injection. Never point the
spray gun at oneself, other persons and animals. Never
touch the spray jet with the fingers or the hand. Due to the
extreme high spray pressure, it causes very serious
injuries. Never use the spray gun without contact protection.
Always secure the spray gun when assembling or
dismantling the nozzle and during an intermission, in order
to avoid accidental operation.
6. When spraying, wear respiratory equipment and safety
glasses. To avoid illnesses follow manufacturer's handling
instructions of the used materials, solvents and cleansing
agents when preparing, processing and cleaning the
equipment. To protect the skin, protective clothing, gloves
and possibly skin lotion are required.
7. The spray gun and the high pressure hose between
machine and spray gun should comply with the rated
pressure of the machine. Exclusively use WAGNER-original
high-pressure hoses.
8. As a result of flowspeed, electrostatic charging is possible.
Upon discharge, this can lead to the formation of sparks or
flames. Therefore, it is essential that the equipment is
always earthed through the electrical installation. The
electrical connection should always be made through
socket outlets with earthing contact in accordance with
regulations.
9. When working indoors, an adequate ventilation should be
guaranteed to exhaust solvent fumes.
10. Extraction systems should be installed on site in
accordance with local regulations.
16 © 2007 J. Wagner GmbH - All rights reserved.
S
AFETY