WAGNER PAINT CREW Mode D'emploi page 17

S
AFETY
INFORMATION BEFORE OPERATING THE EQUIPMENT
11. The objects to be coated have to be earthed.
12. Cleaning of equipment. Never spray off equipment with a
sharp jet, especially not with a high-pressure or steam-
pressure cleaner. Short circuit hazard through penetrating
water.
13. Do not spray any liquid of unknown hazard potential.
14. Cover areas that are not to be sprayed. Keep in mind when
working that wind, for example, can transport paint mist
over great distances and cause damage.
Manual
Congratulations for the puchase of your WAGNER
Airless high pressure spray gun.
Read this manual carefully before the initial use of this
equipment and observe the safety instructions. Keep manual
and safety instructions carefully stored.
You have purchased a quality product wihich requires careful
maintenance and care in order to function perfectly.
Important! After each use, the equipment should be
cleaned.
Not cleaning the equipment leads to malfunctioning! For faults
caused by crud, no guarantee claim will be granted.
In case of malfunctioning, check the cleaned equipment once
again prior to sending it in to the service department.
Technical data Paint Crew
Voltage
Power consumption
Maximum pressure
Flow rate at 140 bar (0 bar)
Maximum temperature of coating material
Maximum sound level
Maximum ambient temperature
Pump system
volume upper container, max.
Turning nozzle, with fast cleaning ability
Weight, ready to spray
© 2007 J. Wagner GmbH - All rights reserved. 1-800-328-8251
I
NFORMATION
Fit a BS 1363A
connected to
230V-240V, 50 Hz
625 W
19,3 MPa
(193 bar)
0,9 l/min
(1,6 l/min)
43°C
81 dBA)*
40°C
piston pump
7,5 l
409 + 515
10,5 kg
17
•
R
EAD ALL
Green and Yello to be connected
approved plug
Blue to be
N (neutral)
Make sure that the
outer sheath of the
cable is held firmly
by the clamp
W
ARNING
If the supply cord of this appliance is damaged, it must only be replaced by
a repair shop appointed by the manufacturer, because special purpose tools
are required.
Warning: Do not connect the blue or brown wire to the earth terminal of the
plug! The wires in this mains lead are coloured in accordance with the
following code:
green/yellow = earth blue = neutral
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifiying the terminals in your plug,
proceed as follows:
The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter E or by the earth
symbol or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal which
is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured brown.
Should the moulded plug have to be replaced, never re-use the defective
plug or attempt to plug it into a different 13 A socket. This could result in
an electric shock.
Should it be necessary to exchange the fuse in the plug only use fuses
approved by ASTA in accordance with BS 1362. 13 Amp fuses may be
used.
To ensure that the fuse and fuse carrier are correctly mounted please
observe the provided markings or colour coding in the plug.
After changing the fuse, always make sure that the fuse carrier is correctly
inserted. With out the fuse carrier, it is not permissible to use the plug.
The correct fuses and fuse carriers are available from your local electrical
supplies stockist.
S
AFETY
to E (earth)
Fit the
recommended
fuse
Browne to be
connected to L
(live)
Never use light
socket
!
brown = live
English