WAGNER PAINT CREW Mode D'emploi page 23

I C
MPORTANT LEANING
N !
OTES
R T N
EAD HESE OTES AND
W B
ARNINGS EFORE
S C
TART TO LEAN
S !
PRAYER
• Clean your sprayer and
components using warm,
soapy water.
• Make sure to dispose cleaning
solution properly when
finished cleaning your
sprayer.
• Thorough cleaning and
lubrication of the sprayer is
the most important step you
can take to ensure proper
operation after storage.
© 2007 J. Wagner GmbH - All rights reserved. © 2007 J. Wagner GmbH - All rights reserved.
C
P
URGING THE
These steps will allow you to recover
excess paint left over in the paint hose.
1. Lock the gun, remove spray tip
assembly, and turn the
PRIME/SPRAY knob to PRIME.
Y
OU
Y
OUR
2. Dump out any remaining spray material
from the hopper back into its container
(see Emptying the Hopper, page 5).
3. Fill the hopper with the appropriate
cleaning solution.
4. Hold the spray gun against the side of
the paint can and hold the trigger.
5. While holding the trigger, turn the
pump ON, and turn the
PRIME/SPRAY knob to SPRAY.
Let the pump run until all paint is
purged from the hose and cleaning
solution is coming out of the gun.
6. Release the trigger and turn the
PRIME/SPRAY knob to PRIME.
7. Hold the spray gun against the side of a
separate container and hold the trigger.
8. Turn the PRIME/SPRAY knob to
SPRAY and trigger the gun until the
fluid coming out of the gun is clear.
You might need to add more cleaning
solution to the hopper.
9. Turn the PRIME/SPRAY knob to
PRIME and trigger gun once more to
relieve pressure.
10. Move on to Rinsing the Hopper.
LEANUP
P H
AINT OSE
SPRAY
23 23
R H
INSING THE OPPER
1. Thoroughly rinse out the hopper
using the appropriate cleaning
solution.
Make sure you do not drip any cleaning
solution into the motor housing.
2. Remove the inlet filter from the
bottom of the hopper and clean. You
may need to use a screwdriver to pry
the filter loose.
Inlet
filter
3. Replace the filter and properly
dispose of the cleaning solution.
F S
LUSHING THE PRAYER
1. Fill the hopper with NEW cleaning
solution.
2. Turn the PRIME/SPRAY knob to
PRIME, turn the pump to ON .
3. Let the pump circulate the cleaning
solution out the return tube for 2-3
minutes.
4. Turn the pump OFF .
5. Properly dispose of cleaning solution
and move on to Cleaning the Spray
Gun Components, next page.
English