Display Deactivation - MC Crypt LumiSTAGE 4/146-10 Notice D'emploi

7. Commissioning
Combined DMX mode
• Press the button MODE (1) until the display (4) shows "dc". "dc" means that the device is in combined DMX mode.
• Briefly after this, the display (4) shows the DMX starting address.
• Set the desired starting address with the buttons UP (2) or DOWN (3). The starting address is assumed after
approx. 3 seconds and displayed alternatingly with the "dc".
• Once a DMX signal is received from the connected DMX controller, and LED flashes at the right side below the
"d" in the display (4).
• In this operating mode, the effect light covers 4 DMX channels. Their functions are listed below.
• The DMX signals from the controller are output unchanged at the DMX OUT (6) port, so that subsequent effect
lights are controlled synchronously.
DMX channel functions:
DMX channel DMX values
CH1 000-255
CH2 000-255
CH3 000-255
CH4 000-127
128-227
228-255

Display deactivation

• The display (4) switches off automatically after 25 seconds without any button being pressed.
• Press any button to activate the display (4) again. This button does not trigger any function yet. Only the next
button pressed when the display (4) is lit will be accepted.
Key Lock
• Press the button MODE (1) for more than 3 seconds to activate the key lock.
• The display (4) shows "LOC", alternating with the operating mode set.
• Press the button MODE (1) again for more than 3 seconds to deactivate the key lock again.
Spot Function
1/2/3/4 Brightness red
1/2/3/4 Brightness green
1/2/3/4 Brightness blue
1/2/3/4 Overall brightness
1/2/3/4 Flashing effect, slow > fast
1/2/3/4 Full brightness, no flashing
39