MC Crypt LumiSTAGE 4/146-10 Notice D'emploi page 38

7. Commissioning
DMX reverse mode
• Press the button MODE (1) until the display (4) shows "dr". "dr" means that the device is in DMX reverse mode.
• Briefly after this, the display (4) shows the DMX starting address.
• Set the desired starting address with the buttons UP (2) or DOWN (3). The starting address is assumed after
approx. 3 seconds and displayed alternatingly with the "dr".
• Once a DMX signal is received from the connected DMX controller, and LED flashes at the right side below the
"d" in the display (4).
• In this operating mode, the effect light covers 16 DMX channels. Their functions are listed below.
• The DMX signals from the controller are output unchanged at the DMX OUT (6) port, so that subsequent effect
lights are controlled synchronously.
DMX channel functions:
DMX channel DMX values
CH1 000-255
CH2 000-255
CH3 000-255
CH4 000-127
128-227
228-255
CH5 000-255
CH6 000-255
CH7 000-255
CH8 000-127
128-227
228-255
CH9 000-255
CH10 000-255
CH11 000-255
CH12 000-127
128-227
228-255
CH13 000-255
CH14 000-255
CH15 000-255
CH16 000-127
128-227
228-255
38
Spot Function
4 Brightness red
4 Brightness green
4 Brightness blue
4 Overall brightness
4 Flashing effect, slow > fast
4 Full brightness, no flashing
3 Brightness red
3 Brightness green
3 Brightness blue
3 Overall brightness
3 Flashing effect, slow > fast
3 Full brightness, no flashing
2 Brightness red
2 Brightness green
2 Brightness blue
2 Overall brightness
2 Flashing effect, slow > fast
2 Full brightness, no flashing
1 Brightness red
1 Brightness green
1 Brightness blue
1 Overall brightness
1 Flashing effect, slow > fast
1 Full brightness, no flashing