Operation With Fixed Colour Settings - MC Crypt LumiSTAGE 4/146-10 Notice D'emploi

7. Commissioning
Functional overview:
Hard colour change effect
SL0 Single chase red/blue/green/yellow
SL1 Single chase orange/pink/turquoise/light green
SL2 Block chase red/blue/green/yellow
SL3 Block chase orange/pink/turquoise/light green
SL4 Fork chase red/blue/green/yellow
The functions SL0-SL9 are identical to the functions A20-A29 in automatic operation.

Operation with fixed colour settings

• Press the button MODE (1) until the display (4) shows "Cxx". "C" means that the device is in fixed colour setting,
"xx" shows the selected colour or colour combination.
• Set the desired colour with the buttons UP (2) or DOWN (3). The different colours are included in the following
list.
• The change is immediate.
• The light intensity is always 100% (full brightness).
In this operating mode, the device does not react to signals pending at the DMX IN (5) connection but
generates the corresponding DMX signals depending on the colour selected (12-channel signals) at
the DMX OUT (6) connection. This makes it possible to control devices connected to DMX OUT (6) and
encoded as slave or slave reverse devices synchronously.
The last colour set is stored even if this operating mode is left in between or the effect light is switched
off.
34
SL5 Fork chase orange/pink/turquoise/light green
SL6 2Side chase red/blue/green/yellow
SL7 2Side chase orange/pink/turquoise/light green
SL8 4C burst red/blue/green/yellow
SL9 4C burst orange/pink/turquoise/light green