Emergency Procedure; Mains Connection - Güde GWS 700 HM-2 Traduction Du Mode D'emploi D'origine

3
ENGLISH
22
all the preventive measures taken.
Residual risks may be minimised by following the
safety instructions and use as designated provisions
and the Operating Instructions.
The exposure to dust is infl uenced by the type of
the material processed. It is important to use local
exhaust (catching near the source) and adjust well
4
PRINT WHITE ON TRANSPARENT MATERIAL
the exhaust covers, guide elements and the grab
USE STRONG PLASTIC MATERIAL - RESISTANT AGAINST
channels.
Dust produced during work is often harmful and
140 x 50 mm
must not get in your body. Use the exhauster and
wear an appropriate respirator, too. Remove tho-
roughly any deposited dust, e.g. by vacuuming.
Use saw blades designed to reduce emitted noise.
Keep the machine and saw blade running.
To minimise noise production, the tool must be
sharpened and all elements for noise minimisation
(covers, etc.) must be properly adjusted.

Emergency procedure

Conduct a fi rst-aid procedure adequate to the
injury and summon qualifi ed medical attendance
as quickly as possible. Protect the injured person
from further harm and calm them down. If you seek
help, state the following pieces of information: 1.
Accident site, 2. Accident type, 3. Number of injured
persons, 4. Injury type(s)

Mains Connection

Operation is only allowed with a safety switch
against stray current (RCD max. stray current of
30mA).
Before putting into operation, a qualifi ed electri-
cian must check whether electric safety measures
required are in place. Any national regulations in this
regard must be complied with.
Electric connection to a socket.
It is necessary to make sure the connecting socket
was not near water and humidity and the plug was
protected against humidity.
Check the voltage. Technical data given on the type
label must correspond with electric network voltage.
Only use splash proof extension cables approved for
outdoor purposes.
Check the cable and/or socket for damages before
the appliance putting into operation.
Never use the charger when the cable, plug or the
machine is damaged by external infl uences. In case
damage let repaired in authorized workshop
To avoid danger, a damaged mains supply pipe must
be replaced by the manufacturer. Do not under any
circumstances attempt any repair yourself.
Cable connections to be separated by pulling the
plug only. Pulling the cable could damage both the
cable and plug. As a result, electric safety would no
longer be guaranteed.
DELAMINATION
Symbols
CAUTION! WARNING
Caution!
Read the operating instructions to reduce
the risk of injury.
Caution!
Unplug the machine before any servicing
or repair!
Always wear goggles when using the
machine.
Wear ear protectors!
Wear safety shoes with steel reinforce-
ment!
Safety gloves to be used!
Wear a respirator!
To be used outdoors only.
Keep dry at all times.. Never expose tool
to rain.
Always keep hands away from the path of
the saw blade.
Keep the machine out of reach of
children.
Keep distance of persons
Observe to keep out of dangerous zone
Warning against thrown-off items
Warning against rotating parts
Warning against dangerous electric
voltage
Warning against cutting injuries