Putting On The Carrying Strap - Grizzly BKS 25 L Traduction De La Notice D'utilisation Originale

allow.any.excessive.pressure.
to.relieve.slowly..Do.not.start.
the.appliance.near.the.place.
of.filling.up..Use.suitable.and.
admissible.vessels.to.keep.
the.fuel.in..Non-compliance.
causes.a.risk.of.fire.or.explo-
sion.
. Use.the.fuel.mixture.recommended.
in.the.manual.only..Verify.that.it.is.
no.older.than.3.months..Non-com-
pliance.may.damage.the.motor.and.
your.warranty.will.be.voided...
. Prevent.petrol.from.coming.
into.contact.with.your.skin.and.
do.not.inhale.petrol.fumes..
Health.risk!
. The.appliance.runs.on.a.40:1.
mixture.of.unleaded.petrol.and.
two-stroke.engine.oil.(API.TC.
quality)..
Table.of.fuel.mixtures:
Petrol Grizzly two-stroke oil
3,00 litres
4,00 litres
5,00 litres
40 parts of petrol + 1 part
Mixing
•. Do.not.use.undiluted.fuel..Only.use.
two-stroke.oil.(no.four-stroke.oil.or.oil.
for.water-cooled.engines)..Non-compli-
ance.may.damage.the.motor.and.your.
warranty.will.be.voided.
1. Prepare the petrol/oil mixture
in a clean canister intended for
use with petrol.
2. First fill in half of the petrol, then
all of the oil, then shake the
canister. Fill in the rest of the
75 ml
100 ml
125 ml
of oil
petrol and shake the canister
again.
D
3. Remove the filler cap and fill the
fuel mixture into the petrol tank.
Wipe spilled fuel from around
the filler opening and replace
the filler cap.
Tests before starting the
appliance
•. Verify.that.the.spark.plug.connector.is.
attached.properly..A.lose.connector.
may.produce.sparks.that.might.ignite.
any.fuel-air.mixture.escaping..
•. Verify.that.all.switches.move.freely.and.
that.the.safety.devices.are.operative.
•. Verify.that.there.is.enough.fuel.in.the.
tank.and.fill.up.as.necessary.
To swivel the cutter head
E
1. Press the stopping lever for the
swivelling cutter head (27).
2. You can now swivel out the
cutter head into four positions.
Use the snap-in points and
allow the stopping lever for
the swivelling cutter head to
properly snap into place.

Putting on the Carrying Strap

. Always.wear.a.shoulder.strap.
when.working.with.the.equip-
ment..Always.switch.off.the.
equipment.before.loosening.
the.shoulder.strap..Risk.of.ac-
cidents.
F
1. Put on the carrying strap (26) and
close the belt buckle (33).
2.. Adjust.the.strap.so.it.fits.tightly.
3.. Adjust.the.strap.so.the.spring.clip.(34).is.
around.10.cm.below.the.hip.
GB
107