Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If you experience any tingling, switch off the device and check that the electrode is in contact with the skin. If the problem
persists, contact the after-sales service: sav@sport-elec.com.
S tarting the program with the belt
3
Once your device is connected, make yourself comfortable and switch it on following the «Starting the device» procedure
detailed in chapter III.
You can carry out your normal activities while using GlobalStim.
E nd of program
4
Once the program has finished, switch off the device and unplug it from the belt.
f
f
Remove the electrodes and moisten them slightly with a few drops of water before replacing them onto their transparent
f
f
plastic backing sheets.
III. STARTING THE DEVICE
This electro-stimulation device is a state-of-the-art appliance; it complies with the standards in force in the field of medical
application.
GlobalStim can be used just with electrodes with a single or both motor units, or with the electro-stimulation belt onto which
the electrodes and the 2 motor units are attached.
NB: It is only possible to work with a single motor unit when using the «master» unit.
The «man machine» interface has been made as simple as possible.
The number displayed on the screen (from 1 to 8) indicates the program selected via the «P» key.
Two graduated scales (1 per channel) located to the left of the screen enable you to see the power level of each motor unit.
You will also find 6 control keys (see diagram chapter V.2):
1 «ON/OFF» key (red icon) - press briefly
f
f
1 «P» key to select the program - press briefly
f
f
1 pair of «+/-» keys on each unit, to adjust the stimulation power of each channel.
f
f
NB: A long press (1 second) on the «-» key brings the power quickly back to zero.
O n/off
1
A brief press on the «ON/OFF» key turns on the device.
f
f
Each time it is switched on, the device carries out an auto-test on 11 safety parameters.
During the auto-test, the screen lights up for ½ second.
If an internal defect is detected, all program numbers flash.
f
f
In this case, switch off your device and send it back to your retailer' s after-sales service.
A long press (of more than 3 seconds) on the «ON/OFF» key activates the auto-test.
f
f
NB: It is possible to stop the ongoing auto-test by switching off the device (press the «ON/OFF» key).
P rogram selection «P»
2
Programs are shown on the right side of the screen by the numbers from 1 to 8.
f
f
Simply press the «P» button briefly one or several times.
f
f
Program numbers are displayed in sequence from 1 to 8 on the screen.
As soon as a program is selected, the corresponding number is displayed (see program details chapter IV).
Once the number of the required program is displayed, start your session by pressing the «+» key on the slave and/or master
f
f
unit.
T he program
3
The program number of the program in use remains lit on the screen for the full duration of the program.
f
f
When a program is running, the «P» key is inactive.
f
f
However, if you have started a session and wish to change the program, you must turn off the device and then switch it back
f
f
on in order to select another program.
There are 64 levels available to regulate the power from 0 to 64.
f
f
- Segments from 0 to 8: there are 6 power levels, or 6 successive presses on the «+» key in order to display the following
- USER MANUAL
11
Publicité
Table des Matières
