Getting Started; S Tarting The Program - SPORT-ELEC Global Stim Mode D'emploi

I. USING THE DEVICE WITH THE ELECTRODES
This function allows you to use the adhesive electrodes by connecting them directly to the motor units.
You can use Global Stim with 1 or both of the 2 units.
To use Global Stim with 1 single unit, use the «master» unit
To use the 2 «master» and «slave» units, please ensure that they are connected using the cable provided.
G etting started
1
Remove the plastic backing sheet from the electrodes (photo 1-A page 2).
f f
Moisten them by spreading a few drops of water onto the adhesive gel using your fingertips and wait 2 minutes (photo 1-B
f f
p. 3).
P ositioning of the electrodes
2
Fix the electrodes to the unit(s) using the snap fasteners (photo 1-C page 2).
f f
Position the unit(s) onto your body (cf positions shown for guidance only.)
f f
NB: The electrodes are for personal use. For hygiene reasons, they must always be used by the same person.
f f

S tarting the program:

3
Start your device by following the «Starting the device» procedure (chapter III).
Contractions should be firm but must never cause any pain.
If the electrodes cause you any discomfort: reduce the power levels, move the electrode(s) and then gradually increase the
power. Also ensure that the electrodes are sufficiently moistened.
Now that the settings have been optimized, let your device get to work for the full duration of the program.
E nd of program:
4
Once the program has finished, switch off the device by pressing the «ON/OFF» button, then disconnect the units.
f f
Gently remove the electrodes from your skin.
f f
Moisten them slightly with a few drops of water and replace them carefully onto their transparent plastic backing sheet.
f f
Keep the adhesive electrodes in a plastic bag in a cool place (for example, a separate compartment in your refrigerator).
II. USING THE DEVICE WITH THE BELT
The GlobalStim belt has 2 pairs of snap fasteners onto which 2 wireless electrodes specially designed by SPORT-ELEC® are
clipped.
To obtain new electrodes, contact your usual retailer or order them from our website www.sport-elec.com.
Warning!
Never use the belt without attaching the 2 electrodes provided.
f f
Only use electrodes supplied by SPORT-ELEC®.
f f
P resentation of the belt:
1
See photos 2 A and B page 2:
1 = Snap fasteners
2 = Wire storage pouch
3 = Velcro strip
4 = Belt extension for larger sizes
C onnection and positioning of the belt.
2
Check that your device is switched off.
f f
Open out the belt.
f f
Fix the electrodes to the inside of the belt using the snap fasteners.
f f
Place the belt around the waist and adjust it using the Velcro strip, so that there is a good contact between the electrodes and
f f
the skin. If required, use the belt extension.
Once the belt is in position, fix the motor units onto the snap fasteners. Connect the lead between the 2 units, and store it in
f f
the wire storage pouch.
10
- USER MANUAL