Troubleshooting; Troubleshooting Table; Changing The Oven Bulb; Protective Glass Panels - Viva VVH33F3 Série Notice D'utilisation

Troubleshooting

Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.

Troubleshooting table

Fault Possible cause Solution/advice
The oven does The fuse has
not work. blown.
Power cut
0
Power cut
The symbol
lights in the dis-
play with some
zeros.
The oven does There is dust in
not work. the contacts.
The oven door The oven door
does not open. has been
H
locked by the
The symbol
self-cleaning
lights up on the
display panel. function
The display The appliance
"‰
has been auto-
shows .
matically turned
off.
Error messages
When the indicator displays an error message with
0
the sensor. The message will disappear. The set time
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
Error mes- Possible cause
sage
"‹‚‚
A sensor has been
pressed for too
long or has got
stuck.
"‚‹‡
The door lock has
been activated with
the door open.
"‚‚†
The temperature
inside the oven is
too high.
:
Risk of electrical discharge and the resulting shock.!
Incorrect repairs can be dangerous. Repairs can only be
carried out by qualified personnel from the Technical
Assistance Service.
38
Check the condition of the
fuse/circuit breaker in the
fuse box.
Check that the light in the
kitchen and other house-
hold appliances are work-
ing.
Set the time once again.
Turn the control knob sev-
eral times in both direc-
tions.
Wait until the oven has
H
cooled and the
turns off.
V
.
Turn the function control
knob to the zero setting.
"
Solution/advice
Press all the sensors one by
one. Check if a sensor is
stuck, covered or dirty
0
Press the sensor. You
can now begin program-
ming again.
The door oven is locked and
heating has stopped. Wait
until the oven has cooled.
0
Press the sensor and
reset the time.

Changing the oven bulb

If the oven light bulb is damaged it must be replaced. Special
25 W, E14, 220 V-240 V heat-resistant light bulbs (to 300 ºC
temperature) can be obtained from the Technical Support
Service or in specialist shops. Only use this type of bulb.
:
Risk of electrical discharge and the resulting shock.!
Disconnect the appliance from the mains. Ensure that this is
turned off.
1. Place a dishcloth into the cold oven to avoid damage.
2. Remove the glass protection by unscrewing it to the left.
3. Replace the bulb with a similar bulb.
symbol
4. Screw the protection glass back into place.
Remove the dishcloth and switch the oven back on at the
5.
mains.

Protective glass panels

Damaged protective glass panels must be replaced. Protective
glass panels cay be obtained from the Technical Assistance
Service. Please quote your appliance's product number and
production number.
, press