Fitting And Removing The Glass Panels - Viva VVH33F3 Série Notice D'utilisation

Fitting and removing the glass panels

The glass panels of the oven door can be removed to make
cleaning easier.
Removing
Unhook the oven door and position it on a cloth with its
1.
handle pointing downwards (figure A).
2. First, unscrew the two lower bolts then the two upper bolts
(figure B).
$
3. Completely remove the door base (figure C).
&
Remove the two clips from the top of the glass (figure D). To
4.
do this, slightly press down on the clip with your thumb and
pull on the tab with your index finger (figure E).
'
Lift the inside glass, push it slightly upwards then remove it
5.
from below (figure F).
)
Clean the glass panels using a glass cleaning product and a
soft cloth.
Do not use abrasive or corrosive cleaning products, glass
scrapers or hard metal scourers as these could damage the
glass.
%
(
Installing
When installing the glass, check that the phrase "right above"
on the bottom left-hand side is upside down.
Insert the interior glass, tilting it upwards and then inserting it
1.
downwards (figure A).
$
2. Refit the clamps on the bottom left and right hand side (figure
B). To do this, hook the clamps in the upper part of the
support and press into place (figure C).
%
3. Refit the entire door base (figure D).
First, screw the two lower bolts into place then the two upper
4.
bolts (figure E).
'
5. Hanging the oven door.
Once the glass panels have been correctly fitted, the oven is
ready to use.
&
(
37