Troubleshooting - StarLab RepeatOne Mode D'emploi

5. Troubleshooting

Error
TipOne Repeat cannot be inserted.
®
Unable to fully lift the filling lever.
Excessive air bubbles when filling the TipOne ® Repeat Dispenser Tip.
Inconsistent dispensing.
Dripping TipOne Repeat Dispenser Tip.
®
RepeatOne ® jams or does not function.
Cause
Filling lever not fully in the down position;
therefore, locking clamp cannot be completely raised.
The dispenser tip piston is not completely inserted in the barrel.
Locking clamp incompletely depressed.
Filling lever lifted slightly before immersing into the liquid.
Leaking TipOne Repeat Dispenser Tip.
®
Volume selection dial has not clicked into position.
Leaking TipOne Repeat Dispenser Tip.
®
Attached TipOne Repeat Dispenser Tip is loose.
®
10
Solution
Depress the filling lever downward and raise the locking clamp as far as it
will go.
Slide the piston into the proper position.
Completely depress the locking clamp.
Draw up some solution and then discard it (using filling lever).
Then refill the TipOne Repeat Dispenser Tip.
®
Replace the dispenser tip with a new one.
Click volume selection dial into position.
Replace with a new dispenser tip.
Use more force to attach the TipOne Repeat Dispenser Tip.
®
Return the RepeatOne ® for repair or replacement.