Important - Invacare Matrx MX2 Back Manuel D'utilisation

4.0 MX2 B
3 MX2 Height Adjustment: The MX2 back height can be adjusted as
necessary, via the slotted channel in the MX2 Back shell (refer to Fig. 8a).
The recommended back height* is approximately 5"-6" (13-15 cm) from
the top of the seat surface (seat cushion or seat pan; Refer to Fig. 8b).
4 Working on one side at a time, loosen the mounting bracket hardware (A),
and slide the MX2 Back shell up/down until the desired back height is
achieved. NOTE: The range of MX2 Back Height Adjustment varies
depending on the height (slot length) on the MX2 Back Shell- see Table 1.0:
5 Tighten the mounting bracket plate/hardware (A) to secure the MX2 back in
place, making certain to maintain the proper mounting pin width/position
(per Fig. 7). Repeat the same back height adjustment on the opposite
mounting bracket.
6 Once all width & height adjustments are finalized, fully secure all hardware.
*Note: The recommended MX2 back height is provided as a guideline
only. Slight variances may be necessary- see Important! note below.
MX2 Installation: Back Height Adjustment
Height Adjustment Slot
Fig. 8a

IMPORTANT!

Always ensure that the bottom of the
back is positioned anotomically
below the Posterior Superior Iliac
Spine (PSIS). If you have any ques-
tions or concerns regarding proper
back height, please contact your
provider and/or health professional
for proper counseling.
- R R
ACK EMOVABLE
A
M I
OUNT NSTALLATION
Table 1.0:
MX2 Height (Slot) Adjustment
Back Shell
Height
6" (150mm)
9" (230mm)
12" (310mm
16" (410mm)
*Recommended Back Height
Seat
5"- 6"
Surface
Range of
Adjustment
1/2" (13mm)
2" (51mm)
2" (51mm)
3.5" (89mm)
13 -15
( cm)
Fig. 8b