Connection; Assembly - Truma CP plus Mode D'emploi

Connection

Please pay attention to the ESD regulations!
– Attach cable (TIN bus) to display and route to heating sys-
tem (to air conditioning system).
– Plug in the 12 V connector cable and attach to unswitched
12 V operating voltage (permanent positive). The positive
cable must be protected with a 1 A fuse.
TIN-Bus
12 V
+ = red
+ -
- = red / black
Rear view:

Assembly

– Fix the control panel frame to the wall with 4 screws.
-
+
Front view:
– Hook control panel upper section into frame using 2 latch-
ing lugs.
– Fix control panel upper section in position with a screw.
– Slide rotary push button onto axis.
Right reserved to make technical changes!
Ø max. 3,4 mm
35