Initial Start-Up; Start-Up; Functions; Switch Control Panel On/Off - Truma CP plus Mode D'emploi

Initial start-up

In order to perform the initial start-up, the following steps are
required:
– Make sure that all equipment is connected to the power supply
12 V DC voltage or
230 V Mains voltage with air conditioning systems and
Combi E.
– Start the search of the devices under menu item
"Service menu" -> "RESET" -> "PR SET".
After pressing, the control panel initialises itself. "INIT .." appears
on the display while this is in progress. The devices that have
been found have therefore been stored in the control panel.

Start-up

Start / standby screen
After connecting the control panel to the mains power supply,
a start screen is displayed after a few seconds.
If no entry is made for several seconds, the standby screen is
automatically displayed.
If the time has been set (see "Set time"), the display
alternates between the time and the room temperature
setting.
After a repair / retrofitting, the procedure described
under "Initial start-up" must be repeated.
22

Functions

The functions in the menu bars (3, 4) of the control panel are
selectable in any order. The operating parameters are shown
on the status bar (2) and on the displays (5, 6).

Switch control panel on/off

– Press rotary push button for longer than 3 seconds.
– Previously set values / operating parameters are reac-
tivated after switching on.
– The control panel deactivation procedure can be
delayed by several minutes because of internal heat-
ing system after-runs.

Select setting level

– Tap rotary push button.
The display shows the setting level. The first icon flashes.