Truma CP plus Mode D'emploi page 26

Enter start time
– Set the hours then the minutes with the rotary push button.
Enter finish time
– Set the hours then the minutes with the rotary push button.
If the start/end point was exceeded during entry, the
operating parameters are not taken into consideration
until the next start/end point has been reached. Until then,
the operating parameters that have been set outside the time
switch remain valid.
26
Set room temperature
– Select heating or air conditioning system using the rotary
push button, depending on the unit that is connected.
– Tap rotary push button to confirm selection.
– Select required room temperature with rotary push button.
– Tap rotary push button to confirm value.
Set hot water level
– Select required hot water level with rotary push button.
– Tap rotary push button to confirm value.
Select energy source
– Select required energy source with rotary push button.
– Tap rotary push button to confirm value.
The select energy type menu is displayed if a heating
system with electric heating elements is connected.