Operating Instructions; Symbols Used; Intended Use; Safety Instructions - Truma CP plus Mode D'emploi

Operating instructions

Symbols used

The unit must only be installed and repaired by an
expert.
Note containing information and tips.
Please pay attention to the ESD regulations! Elec-
trostatic charge can destroy the electronics. Ensure
that potential compensation is present before touching the
electronics.

Intended use

The Truma CP plus control panel is used to control and
monitor a Combi CP plus ready heating system and/or a
Truma air conditioning system. The following air conditioning
systems can be operated with the Truma CP plus:
– Saphir compact *, **
– Saphir comfort RC
– Aventa eco
– Aventa comfort
* not in conjunction with a TG 1000 Sinus power inverter
** in combination with a Combi CP plus ready heating system
a "control panel cable coupling" is essential between the
air conditioning system and the heating system. The "con-
trol panel cable coupling" (part no. 40090-69300) can be
ordered separately.
The device is intended for installation in caravans and motor
homes. Installation in boats is not permitted.
20
The Truma CP plus control panel can be retrofitted in
old heating systems. The heater electronics must be
replaced (by Truma Service) to do this.

Safety instructions

– The device must not be operated unless it is in technically
perfect condition.
– Repairs must be carried out immediately. Only carry out
repairs yourself if the solution is described in the trouble-
shooting guide of this manual.
– No repairs or modifications to the unit are allowed!
– Defective devices may only be repaired by the manufacturer
or the manufacturer's service department.

Important notes

If the power supply to the system has been interrupted, the
time must be re-entered.
– The Combi CP plus ready heating system can no longer be
switched using a ZUCB time switch if it is connected to the
Truma CP plus control panel.
– If a new device is connected to the bus system, the proce-
dure described in "Initial start-up" must be repeated.
Air conditioning systems – shared use of IR remote
control and control panel
– Even after connecting the Truma CP plus control panel, the
IR remote control is available for controlling the air condi-
tioning system. The control panel recognises all settings
that are made using the IR remote control on the air con-
ditioning system. The IR remote control only transmits
the settings that are shown in its display (no bidirectional
communication).
– Only the time switch of the control panel may be used to
clearly define the start and end time of a required period.