Select Fan Level; Set Time Switch - Truma CP plus Mode D'emploi

Select fan level

With connected heating / air conditioning system
– Select icon in menu bar (3) with rotary push button.
– Change by tapping in the setting level.
– Select desired fan level with rotary push button.
– Tap rotary push button to confirm value.
a
2
3
Heating system
Icon Operating
mode
– OFF
a VENT*
b ECO
c HIGH **
d BOOST
b c d e
Description
Fan is switched off.
(only selectable if no unit is in
operation).
Air circulation if no unit is in
operation. 10 speed settings
available.
Low fan level
High fan level
Rapid room heating
Available if the difference
between the selected and the
actual room temperature is
>10 °C
* Can lead to additional motor wear depending on frequency
of use.
** Fan level "HIGH" results in higher power consumption,
higher noise level and increased motor wear.
As soon as the heating system is switched on (room
temperature, hot water level selected) the status bar dis-
plays the fan level that was selected during the previous heat-
ing procedure. The factory setting is "ECO".
Air conditioning system
Icon Operating
mode
– OFF
a –
b LOW
c MID
d HIGH
e NIGHT

Set time switch

– The time switch can only be selected if the time has
been set at the control panel.
– When air conditioning systems are being operated,
the control panel time switch must only be used to clearly
define the start and end time for a required period of time.
– If the time switch has been activated (ON), the deacti-
vate time switch menu is displayed first (OFF).
– Select icon in menu bar (4) with rotary push button.
– Change by tapping in the setting level.
Description
Fan is switched off
(only selectable if no unit is in
operation).
–
Low fan level
Medium fan level
High fan level
Extremely quiet fan operation
25