230 V Mains Power Supply Indicator; Warning - Truma CP plus Mode D'emploi

Reset to factory settings (RESET)
The reset function resets the control panel back to the factory
settings. All settings will be deleted. New units that have been
connected are stored in the control panel.
Perform Reset
– Select "RESET" with rotary push button.
– Tap rotary push button.
– "PR SET" appears on the display.
– Tap rotary push button to confirm.
After pressing, the control panel initialises itself.
"INIT .." appears on the display while this is in progress.

230 V mains power supply indicator

The icon signals that 230 V mains power supply is available.
Display is only possible in combination with a heating
system Combi E CP plus ready which contains additional
heating elements for electrical mode.

Warning

In the event of a warning a warning symbol appears in order
to signal that an operating parameter has reached an unde-
fined condition. In this case the device concerned continues
to operate. As soon as the operating parameter is within the
target range again, this symbol goes off again automatically.
Read out code of warning
– Select icon with rotary push button.
– Tap rotary push button.
The current warning code will be displayed. The cause
of the warning can be determined using the fault list and
eliminated.
W = Warning
42 = Fault code
H = Device
Cause eliminated / return to setting level
– Tap rotary push button.
Cause not eliminated / return to setting level
– Press the return button.
H = Heating system
A = Air conditioning system
29