Change Room Temperature; Change Hot Water Level - Truma CP plus Mode D'emploi

Change room temperature

– Select icon in menu bar (3) with rotary push button.
– Change by tapping in the setting level.
– Select between heating system (HEATER) or air condition-
ing system (AC) using the rotary push button, depending on
the unit that is connected.
– Tap rotary push button to confirm selection.
– Select desired temperature with rotary push button.
– Tap rotary push button to confirm value.
a b
Heating system (HEATER)
Adjustable temperature range 5 - 30 °C (steps of 1 °C)
a = Heating system *
* This symbol flashes until the required room temperature has
been reached.
Quick temperature change using rotary push button
possible (in Stand-by screen).
Air conditioning system (AC)
Adjustable temperature range 16 - 31 °C (steps of 1 °C)
b = COOL – Air conditioning system is switched on
c = AUTO – Air conditioning system is set to automatic
d = HOT – Air conditioning system is in heating mode
e = VENT – Air conditioning system is in air circulation mode
c d e
2
3
– Heating system is switched on.

Change hot water level

– Select icon in menu bar (3) with rotary push button.
– Change by tapping in the setting level.
– Select desired level with rotary push button.
– Tap rotary push button to confirm value.
a b
2
3
a = Boiler * – Hot water generator is switched on.
b = 40° ** – Hot water temperature 40 °C
c = 60° – Hot water temperature 60 °C
d = BOOST * – Targeted, rapid heating of boiler contents
(Boiler priority) for a maximum time window
of 40 minutes. Then the water temperature is
kept at the higher level for two post-heating
cycles (about 62 °C) – not Combi Diesel. After
reaching the water temperature, heating of the
room continues.
* This symbol flashes until the required water temperature
has been reached.
** A hot water temperature of 40 °C can only be maintained
with combined room and water heating for a limited time.
Not available for the Australian variants.
c d
23