Arjohuntleigh Nimbus 3 Mode D'emploi page 23

For all alarm conditions except
been detected and displayed, it can only be cancelled by switching the pump
unit off and then back on.
PUMP FAULT
POWER Fail
Service Indicator
The pump will continue to operate normally even when the
illuminated.
• LOW PRESSURE
page 12).
• HIGH PRESSURE
page 12).
(Refer to "PUMP FAULT" on
• PUMP FAULT
page 13).
• (Refer to "POWER Fail" on page 13).
POWER
Power Fail
Refer to Section 8, Page 27 "Troubleshooting" for
possible causes of the above alarm conditions.
The
PUMP FAULT
internal pump malfunction is detected.
The fault can only be rectified by carrying out a service
on the pump.
The indicator will flash when a mains power
POWER
failure has been detected.
The alarm will continue until the mains power is
resumed or the pump is switched off using the
switch on the pump control panel.
The symbol will be illuminated after a set number of
running hours to indicate that the pump is ready for a
service.
This service period is set to 12 months.
13
(Refer to "LOW PRESSURE" on
(Refer to "HIGH PRESSURE" on
, once the alarm condition has
indicator is illuminated when an
POWER
symbol is