Arjohuntleigh Nimbus 3 Mode D'emploi page 29

Silencing Audible
Alarms
In its normal operating mode an audible alarm can only be silenced after an
alarm has occurred. An internal setting can be used to change the mode of
operation so that this button can pre-silence an alarm. Call your service
engineer if this option is required.
Comfort Control The mattress cell pressure can be manually adjusted for
The system automatically compensates for patient size, height, position and
weight distribution to provide optimum support regardless of the
setting.
CONTROL
Transport Control This seals the mattress and allows the removal of the
If the Transport control is set to
the pump switched on, then the pump will indicate a
alarm.
To change the operating mode:
1. To select
Static
button once. An audible tone will sound
STATIC
and the indicator on the button will illuminate to
show that the system is in
2. To select
Dynamic
button once. An audible tone will sound
STATIC
and the indicator on the button will extinguish.
Audible alarms can be silenced using the
To silence an alarm push the
indicator on the
MUTE
patient comfort using the rotary
To change the comfort setting:
• Turn
COMFORT CONTROL
setting and counterclockwise for a softer setting.
• The mattress minimum pressure is maintained at the
chosen level.
pump for patient transport. The patient will remain
supported by the mattress for up to 12 hours in
mode. To set the
Transport
1. At the foot end of the mattress turn the Transport
control knob clockwise to
2. Turn the pump off and disconnect the tubeset.
TRANSPORT
To resume normal operation:
1. Re-connect the pump and tubeset to the mattress.
2. Turn the Transport control knob counterclockwise
to .
NORMAL
19
mode from
Dynamic
mode.
Static
mode from
Static
button once (the
MUTE
button will remain illuminated).
COMFORT CONTROL
clockwise for a firmer
mode:
TRANSPORT
with the tubeset connected and
Low Pressure
mode press the
mode press the
button.
MUTE
.
COMFORT
Transport
.
fault