Read This First; Applications - Marmitek GIGAVIDEO 50 Mode D'emploi

READ THIS FIRST!

Caution: to reduce risk of electric shock, do not disassemble any part of the
videosender system. No user-serviceable parts are inside. If you spill liquid on it,
disconnect the unit from the AC outlet to prevent possible fire or shock hazard
and consult authorized service personnel.
Use only the supplied powersupplies. Defective parts must be replaced by
original spareparts only.
Powerline operated equipment or accessories connected to the unit should bear
the CE certification mark and should not be modified in any way that might defeat
the safety features.
Warning: to prevent electric shock hazard, do not expose any part of the video
Sender to rain or moisture. Do not use near a bath tub, swimmingpool, etc.
Disconnect the unit during thunderstorms from mains and other connected
equipment to avoid damage.
No guarantee or liability will be accepted for any damage caused due to incorrect
use of the equipment supplied, other than indicated in this owner's manual.

APPLICATIONS:

The Marmitek GigaVideo 50 is designed to transmit audio and video signals,
without running wires.
In some models there is a second radio transmission system providing a infra-red
return path enabling you to control your VCR or Satellite Receiver from a remote
location.
- Watch a movie on any TV in Your home without moving your VCR or
running cables.
- Watch satellite programs on any TV anywhere in your house.
- Watch DVD movies from your PC on your TV in a remote location
- Listen to MP3 audio from your PC on your Hifi system in the livingroom
- Monitor your sleeping baby, eldery or disabled on your TV by using
your videocamera or CCD camera.
- Make perfect demonstrations without wiring TV's during trade-shows,
seminars, etc.
1. SETTING UP THE MARMITEK GIGAVIDEO TRANSMITTER:
1. Connect one set of Audio/Video cables to the VIDEO [C] and AUDIO [D] jacks
of your Marmitek GigaVideo Transmitter. Take care to match the colors of the
plugs on the cable with the jacks on the GigaVideo Transmitter.
2. Connect the other end of the cable to the Audio/Video OUT jacks of your VCR,
Satellite receiver or TV. If a scart connection is provided, use the scart adaptor
labelled "Transmitter". Connecting the transmitter to your VCR or Satellite
receivers, allows you to choose channels independent from your main TV. If the
jacks are colored differently, connect the yellow plug on the jack VIDEO, the red
plug on the jack AUDIO RIGHT and the white plug to the jack AUDIO LEFT.
3. . Switch the Power slide switch on the side into the "OFF" position
OWNER'S MANUAL
3