Marmitek GIGAVIDEO 50 Mode D'emploi page 4

4. Plug the supplied mains adaptor, labelled Sender/Transmitter 200mA, into a
230Volt -50Hz wall outlet and connect the jack to the 12V jack at the rear side of
the transmitter. Only use the supplied mains adaptor!
5. Switch the Power switch to the ON position.
6. Set the Channel-switch [A] on A.
7. Position the transmitter in a convenient location and orient the antenna [K]
If you have several A/V components:
If you have two or more A/V components (e.g. VCR, Cable box, Laserdisc or
satellite receiver) that you want to watch in another room, they will probably
already been hooked up to the local TV in series. To connect the GigaVideo
Transmitter you just need to indentify the last component in the chain and
connect the Line OUT or scart to the GigaVideo Transmitter IN jacks.
If the last component does not have spare LINE OUT jacks or a spare Scart
connector, you may connect the local TV using the antenna (VHF/UHF) output,
while connecting the Videosender to the A/V output. You may use a Scart splitter
cable, available through your local dealer, to create a extra output on your
equipment.
2. SETTING UP THE MARMITEK GIGAVIDEO RECEIVER:
1. Connect a set of Audio/Video cables to the LINE OUT jacks [H+I] of
your GigaVideo Receiver. Connect the other end to your TV. If your TV
has a Scart connector, you may use the Scart adaptor provided;
labelled: "Receiver".
2. On some models a so called modulator is provided (RF Output).
Connect the receiver to the antenna or RF input of your TV (pre-set at
channel 36 or 48). You will need a short male/female 'aerial converter'
lead, available from your dealer.
3. Switch the Power slide switch on the side into the "OFF" position
4. Plug the supplied mains adaptor, labelled Receiver 500mA, into a
230Volt -50Hz wall outlet and connect the jack [E] to the 12V jack at
the backside of the receiver. Only use the supplied mains adaptor!
5. Switch the Power switch [B] to the ON position.
6. Set the Channel-switch [A] on A.
7. Put the side antenna [on some models only [J] of the remote control
extender in an upright position
4