Marmitek GIGAVIDEO 50 Mode D'emploi page 5

3. FINE TUNING YOUR MARMITEK GIGAVIDEO SET:
Make sure your A/V equipment is switched on. Switch the receiving TV on and
select the A/V channel (normally found on the "0" or "AV" button. The picture
should now automatically be there, no tuning is required.
The wireless GigaVideo usually works best with the indented faces of the
antennas [K] on the Transmitter and Receiver unit look at one another.
Sometimes however distance, reflections and other effects in the home may
affect the signal so that some adjustment of either Transmitter or Receiver
antenna may be necessary to get the best signal.
If still experiencing difficulty, try changing the "ABCD" channel selector and
change channels. Remember though both the receiver and transmitter must be
on the same channel.
If you are not getting any signal at all:
Check that the units are connected to mains and that the Power-switch is in the
ON position. Check that the Channel slide switch (labelled A-D) on both
GigaVideo units is set at the same number. Check if the receiving TV is on the
correct A/V channel.. If the unit is supplied with an infrared returnpath (some
models only) : Raise the small black side antenna [J] to an upright position.
4. THE REMOTE EXTENDER FEATURE (on some models):
If an Infrared Extender is provided, your Marmitek VideoSender has the ability to
transmit infrared signals from your own remote control from your receiving TV
back to the equipment connected to videosender. For example, you can change
channels on your satellite receiver while viewing in another room. Simply point
your original remote control to the IR window on the front of your GigaVideo
Receiver. The IR signal is now transmitted by radio to the GigaVideo transmitter.
Set up is simple, ideally with 2 people. Locate the mini IR emitter (the only item
left now) and connect the small jack plug on the back of the Receiver (IR) The
thin cable contains two IR emitters that have a self adhesive back surface. This
must be placed over the IR receiving eye on front of your VCR and/or Satellite
receiver. Normally this area is to be recognized by a smoked or dark plastic
window. Remove the small paper protective label and affix the emitter very lightly
on the facia of your equipment.
Now with your own remote control go to the VideoReceiver and point your
remote at the front of the receiver and press the channel change buttons in the
normal way.
Now the channel changes, if not, go back to the transmitter and move the sticky
back emitter. The position sometimes is critical. Once satisfied press the emitter
firmly on the suface (this will not damage your equipment).
If you have problems with the range, try to move the receiver and/or transmitter
away from your connected equipment. This can greatly increase performance of
the radio transmission.
Copyright Marmitek X-10
The right is reserved to make technical modifications
Marmitek 10-2000 Rev2
5