Table des Matières
Publicité
10
12
15
502020.75.25_021V4D0102_1012_IM_bernette 10 12 15_EN_ES_FR_PT
Inserting the needle
EN
Attention:
Turn power switch to "O" before inserting or
removing the needle.
Change the needle regularly, especially
if it is showing signs of wear and causing
problems.
Insert the needle as illustrated:
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle. (1)
B. The flat side of the shaft should be
towards the back.
C/D.Insert the needle as far up as it will go.
Needles must be in perfect condition. (2)
Problems can occur with:
A. Bent needles
B. Blunt needles
C. Damaged points
Publicité
Table des Matières
