Assembly Diagram - Palazzetti A78 Manuel D'installation, D'utilisation Et De Maintenance

7.3 Assembly diagram

1) For correct installation, all the joints of the
flue gas ducting between the fireplace and
the flue must be sealed.
2) Lining in eco-friendly ceramic fibre or rock
wool with external aluminium foil.
3) Rear external air intake, ensure a minimum
distance of 5 cm between cladding and com-
bustion air intake pipe.
4) Provide an opening of a suitable size for clean-
ing and servicing the room fan (for model
AC78 only).
5) The lining must be made of fireproof material.
6) Min distance. 1 cm between cladding and
fireplace stove.
7) Protect any wooden parts with fireproof
material.
8) Counter-hood and fireproof load-bearing
structure.
9) Pellet loading system. See the instructions
supplied with the kit for installation.
10) UNI standards require the installation of a
heat recovery grille as close as possible to the
ceiling.
68
A
B
C
Fig. 33
10
9
8
7
6
5
4
7.3.1 Insertion of room sensor
The sensor must be installed near the side or
front suction holes of the cladding base.
Glue the probe wire in correspondence with the
air intakes
1
2
3
4
Fig. 34
Fig. 35
004778890 - 12/11/2021