Assembly Diagram - Palazzetti INSERIMENTO SMALL 54T Notice D'installation

6.3 ASSEMBLY DIAGRAM

(Fig. 6.3)
A) For proper installation, the smoke ducting between the
replace and the ue must have all joints sealed.
B) Rear external air intake, ensure a minimum distance of 5
cm between cladding and combustion air intake pipe.
C) UNI standards require the installation of a heat recovery
grille as close as possible to the ceiling.
D) Counter-hood and reproof load-bearing structure
E) Cladding in ceramic bre or rock wool with external
aluminium foil
F) Protect any wooden parts with reproof material.
G) Min distance. 1 cm between cladding and replace stove
H) The cladding must be made of reproof material
Fig. 6.3.1 In the product technical detail shows the
minimum distances in centimeters to be observed
in the placement of the replace with respect to
materials and combustible objects.
Leave enough room for maintenance
Assembly must be carried out by qualified
personnel.
• If there are ammable materials or structures
on the back of the rebox, they must be at a
minimum distance of 10 cm.
• To ensure correct installation, the smoke pipe
between the replace and ue must be airtight,
sealing all the joints.
• If the fireplace is installed with a flue that
has already been used with other replaces,
it should be cleaned thoroughly to avoid
malfunctions and the danger of unburned parts
deposited on the inside from catching re.
• Improper installation may compromise the
safety of the unit.
• It must be possible for quali ed personnel to
access the inside of the stove when it is not in
operation.
• The cladding must be in reproof material and
it must not have any removable parts, so that
electrically powered and moving parts are not
accessible by the user.
• Do not place ammable objects or materials
in the radiation area of the hearth, and in any
case not less than 1 m.
32
INSTALLATION
F
G
H
DISTANZA MINIMA DAI MATERIALI COMBUSTIBILI
00 4776980 - 06/2018 - PN - Italy
Fig. 6.3
C
D
Z
Fig. 6.3.1
A
E
B