Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. 1
HANDLING
Before moving the unit, examine the
dimensions, weights, centre of mass
and lifting points, then check that the
equipment for lifting and positioning
is suitable and complies with safety
regulations currently in force.
Particular attention must be paid to
all the loading, unloading and lifting
operations so as to avoid hazardous
situations for people and damage to
the structure and operational parts of
the machine.
IT IS absolutely forbidden to leave
objects on the unit.
Personnel engaged in handling the
machine must have the proper personal
protection devices.
Under no circumstances must anybody
or anything stop under the unit, even
briefly.
- Check that the cables are type-
approved to support the weight of
the unit, and make sure they are
1.2. 1
Example of handling - minimum technical clearances
S1
S4
S3
2
RECEIVING THE PRODUCT
1
well fixed.
- The lifting frame must have the
lifting point on the vertical of the
centre of mass (the axes of the
centre of mass are indicated by
adhesive labels on the base).
During lifting you are advised to fit
anti-vibration mounts, fixing them to
the Ø 20mm holes on the base unit in
accordance with the assembly layout
supplied with the accessories (AVX).
1.2
LOCATION
The machines of the NRA series must
be installed externally, in an area
suitable for the purpose and with the
required technical clearances.
This is essential, both to allow routine
and
extraordinary
maintenance
interventions,
and
for
needs, as the device must gather air
from the outside, along the perimetric
sides, and expel it upwards. For the
correct working of the unit, it must
MOD.
Minimum technical clearances
mm
S1
800
S2
be installed on a perfectly horizontal
surface. Make sure that the resting
surface is able to bear the weight of
the machine. The device is made of
galvanised steel sheet and hot painted
with polyester powders to resist bad
weather. This means that no particular
measures have to be taken to protect
the unit. If the machine is to be placed
in a particularly windy position, wind
breaks must be provided to avoid
the DCPX operating in an unstable
condition.
NOTE:
the device must be installed in such a
way as to make all maintenance and/
or repair operations possible.
The warranty of the device does not
in any case cover costs incurred
operational
as a result of motorised ladders,
scaffolding or any other lifting
systems made necessary to carry out
the operations under warranty.
The inner diameter of the
lifting holes of the flange is
70mm
S2
S3
800
800
S4
height
1100
3000
Fig. 1
Publicité
Chapitres
Table des Matières
