Before Machine Start-Up - Clarke Vantage 17 Battery Manuel D'utilisation

BEFORE MACHINE START-UP

To prepare the machine for operation, follow this procedure
before start-up.
Squeegee Installation
1. Install the squeegee (A, Fig. 10) and fix it by means of the
squeegee knobs (B), then connect the vacuum hose (C)
to the squeegee.
Solution Tank Filling
2. Fill the solution tank (A, Fig. 11) with a solution suitable
for the work to be carried out.
Do not fill the solution tank completely, leave few inches
from the edge.
Always follow the dilution instructions on the container
label on the chemical product used to create the solution.
The solution temperature must not exceed 100°F (40°C).
CAUTION
Use only low-foam and non-flammable liquid
detergents, intended
applications.
Brush or Pad-Holder Installation
NOTE
According to the kind of cleaning to be carried out,
the machine can be equipped both with the brush (B,
Fig. 11) and the pad-holder (C) with pad (D).
3. Deactivate the transport/parking device (A, Fig. 12) by
putting it in position (B) after inserting the relevant pin (C).
4. Lift the brush cover (D, Fig. 12) by prying the handlebar
(E).
5. Place the brush (B, Fig. 11) or the pad-holder (C) with
pad (D) under the cover.
6. Lower the cover (D, Fig. 12) by means of the handlebar
(E).
7. Press the brush push-button on "I" (Fig. 12, F), then press
on or both push-buttons (Fig. 12, G) for a few seconds.
If the hooking operation is difficult, manually rotate the
brush/pad-holder counterclockwise (Fig. 13).
Figure 13
Operator's Manual - Vantage 17 Battery
for automatic scrubber
ENGLISH
Figure 10
Figure 11
Figure 12
EN
13