Recovery Tank Removal; Stored Machine - Clarke Vantage 17 Battery Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

RECOVERY TANK REMOVAL

To check the batteries, or to perform other operations, it may
be necessary to remove the recovery tank (A, Fig. 23)
according to the following procedure:
1. Empty the tank (A, Fig. 23) according to the procedure
shown in the relevant paragraph.
2. Drive the machine on a level ground.
3. Make sure that the switches (A and B, Fig. 22) are in the
"0" position.
4. Disconnect the vacuum hose (C, Fig. 22) from the
squeegee (D).
5. Disconnect the recovery tank drain hose (E, Fig. 22) from
the bracket (F).
6. Open the cover (B, Fig. 23) and apply the cover stand
(C).
7. Grasp the recovery tank (A, Fig. 23) in the area (D) and
slightly lift it, as shown in the figure.
8. Disconnect the vacuum hose (E, Fig. 23) from the tank,
then remove the tank (A) with the hoses (F) and (G).

STORED MACHINE

If the machine is not going to be used for more than 30 days,
proceed as follows:
1. Perform the operations described in the After Using the
Machine paragraph.
2. Remove the recovery tank (A, Fig. 23) according to the
procedure shown in the previous paragraph, then
disconnect the battery negative terminals.
3. Reinstall the recovery tank (A, Fig. 23).
4. Store the machine in a clean and dry place, with the
brush/pad and the squeegee lifted or removed.
Operator's Manual - Vantage 17 Battery
ENGLISH
Figure 22
Figure 23
EN
17

Publicité

Table des Matières
loading

Table des Matières