Table des Matières
Publicité
2
Figure 5
Page -20 -
1
2
HOW TO OPERATE THE MACHINE
How To Start/Stop The Machine
WARNING:
Never start a polisher when
the handle is in the vertical
position.
The following steps apply to MP-1800:
The switch to start and stop the machine is activated
by the interlock switch (1) and the levers (2) under the
handle grips. See figure 5.
To start the machine, follow this procedure:
1. Lower the handle
2. Lock the handle in the best position for operation.
NOTE: Make sure you hold the handle with both
hands.
3. Push the interlock switch (1), and apply pressure to
the levers (2). See figure 5.
How To Control The Machine
NOTE: Make sure you hold the handle with both
hands.
The side to side movement of the machine is controlled
by raising the handle and pressing down on the handle.
To move the machine to the left, press down on the
handle slightly. To move the machine to the right, raise
the handle slightly.
MAINTENANCE
WARNING: Maintenance must be done
by authorized personnel
only.
Maintenance Instructions
Return the machine to a Clarke Authorized Service
Location every 12 months for maintenance inspections.
®
Clarke
Operator's Manual - MP-1800 Marble Polisher
Publicité
Table des Matières
