Machine Transport Procedures; Symbols Shown On The Machine - Clarke Vantage 17 Battery Manuel D'utilisation

EN
ENGLISH

MACHINE TRANSPORT PROCEDURES

How to Load and Unload the Machine from a Van or a
Truck
WARNING!
This machine is heavy. Machine transfer must be
performed by qualified personnel only. Machine
transfer on steep ramps must be performed by two
well-trained operators only. Always move it slowly.
Do not turn the machine on slopes. Do not leave the
machine unattended on slopes. Loading ramp width
must not be less than 40 in (1 m).
1. Check that the loading ramp is not longer than 8 feet (2.5
m) and not wider than 40 inches (1 m). Its thickness must
be adequate to support the machine and operators'
weight.
2. Check that the ramp is dry and clean.
3. Position the ramp properly.
4. Before loading the machine, remove the squeegee
assembly and the brush/pad holder. Before loading the
machine, empty both the solution and the recovery tank.
How to Fasten the Machine Inside the Vehicle
5. Clarke recommends
transporting.

SYMBOLS SHOWN ON THE MACHINE

7
tying down machine
WARNING!
Carefully read all
maintenance/repair procedure.
WARNING!
Do not wash the machine with pressurized water.
WARNING!
Do not open the cover. Electric danger!
when
maintenance/repair instructions
Operator's Manual - Vantage 17 Battery
Figure 1
before performing any