Before Machine Start-Up - Clarke Vantage 17 Manuel D'utilisation

BEFORE MACHINE START-UP

To prepare the machine for operation, follow this procedure
before start-up.
Squeegee Installation
Install the squeegee (A, Fig. 10) and ix it by means of the
1.
squeegee knobs (B), then connect the vacuum hose (C) to
the squeegee.
Solution Tank Filling
2. Fill the solution tank (A, Fig. 11) with a solution suitable for
the work to be carried out.
Do not ill the solution tank completely, leave few inches
from the edge.
Always follow the dilution instructions on the container label
on the chemical product used to create the solution.
The solution temperature must not exceed 100°F (40°C).
CAUTION!
Use only low-foam and non-lammable liquid
detergents, intended for automatic scrubber
applications.
Brush or Pad-Holder Installation
NOTE
According to the kind of cleaning to be carried out, the
machine can be equipped both with the brush (B, Fig.
11) and the pad-holder (C) with pad (D).
Deactivate the transport/parking device (A, Fig. 12) by
3.
putting it in position (B) after inserting the relevant pin (C).
Lift the brush cover (D, Fig. 12) by prying the handlebar
4.
(E).
Place the brush (B, Fig. 11) or the pad-holder (C) with pad
5.
(D) under the cover.
6. Lower the cover (D, Fig. 12) by means of the handlebar
(E).
Press the brush push-button on "I" (Fig. 12, F), then press
7.
on or both push-buttons (Fig. 12, G) for a few seconds.
If the hooking operation is dificult, manually rotate the brush/
pad-holder counterclockwise (Fig. 13).
Figure 13
Operator's Manual - Vantage 17 Battery
ENGLISH
Figure 10
Figure 11
Figure 12
13