Before Machine Start-Up - Clarke Vantage 17 B Mode D'emploi

BEFORE MACHINE START-UP

Brush or pad-holder installation
NOTE
Use either the brush (54) or the pad-holder (55 and 56) according to the type of loor to be cleaned.
1. Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
2. Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3. Place the brush (54) or the pad-holder (55 and 56) under the deck.
4. Lower the deck (10) by using the handlebar (2).
5. Turn the switch (62) to "I".
6. Press the brush enabling push-buttons (61) to engage the brush/pad-holder to the deck hub (10). If necessary, repeat the
procedure until the brush/pad-holder is engaged.
Available brushes and their relevant application guides (suggestions only)
Models
Concrete
Terrazzo loor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing Marble
Vinyl tiles
Squeegee installation
7. Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
Solution tank illing
CAUTION!
Use only low-foam and non-lammable detergents, intended for automatic scrubber applications.
WARNING!
When using loor cleaning detergents, follow the instructions on the labels of the detergent bottles.
To handle loor cleaning detergents, wear suitable gloves and protections.
Use the iller neck (45) to ill the tank (31) with a solution suitable for the work to be performed. Do not ill the solution tank
8.
completely, leave few inches from the edge. Always follow the dilution instructions on the label of the chemical product used to
prepare the solution. The solution temperature must not exceed 104 °F (40 °C).
INSTRUCTIONS FOR USE
MIDLITE GRIT 180 MIDGRIT 240
9099650000 - VANTAGE 17 B
ENGLISH
PROLITE UNION MIX
13